Installation guide

Installation – Mounting the Range Hood

For Mounting Under a Kitchen Cabinet (Fig 1)

1. Select preferred duct location (vertical or horizontal).

2. Begin installation by removing the ﬁ lters (if installed).

3. Reinforce cabinet with 1”x2” wood strips if additional

strengthening is required or if cabinets are framed.

4. Temporarily position the range hood in the desired

mounting location. Measure and mark the mounting

holes, duct and electrical locations with a pencil.

5. Drill/cut out the required openings for duct and

electrical access by following the dimensions on page

8; make sure the duct opening is large enough to apply

duct tape.

6. Fasten hood onto cabinet with (4) M4 wood screws

provided.

7. Install electrical.

8. Install duct work and duct tape.

9. Reinstall ﬁ lters.

10. Power up hood and check for leaks around duct tape.

duct/silver

tape

Duct

opening

cutout

Add 1x2

wood strips

electrical

Fig 1

(Shown as vertical ducting)