MSDS

Safety Data Sheet
Product Name
Instant Spot & Stain Remover
Product code
ZUSPOT
Butyl Cellosolve; Ethylene Glycol Monobutyl Ether; 2-Butoxyethanol 111-76-2 5 - 15
Butane 106-97-8 1 - 10
Dipropylene glycol monobutyl ether; Glycol Ether DPnB; 1-(2-butoxy-1-methylethoxy)
propan-2-ol
29911-28-2 1 - 5
acetone 67-64-1 1 - 5
propane 74-98-6 1 - 5
sodium nitrite 7632-00-0 0.1 - 1
Eye Contact
Skin Contact
Inhalation
Ingestion
Immediately flush eyes with plenty of water, occasionally lifting the upper and lower eyelids. Check for and
remove any contact lenses. Continue to rinse for at least 10 minutes. Get medical attention if irritation occurs.
Flush affected skin with plenty of water. Remove contaminated clothing and shoes. Get medical attention if
symptoms occur.
If inhaled, remove to fresh air. If irritation persists, get medical attention.
Do not induce vomiting unless directed to do so by medical personnel. Never give anything by mouth to an
unconscious person. If material has been swallowed and the exposed person is conscious, give small quantities
of water to drink. Get medical attention immediately.
Section 4. First Aid Measures
N
ot available.
Flash Point
N
ot applicable.
National Fire Protection Association (U.S.A.)
1
1
0
Flammable Limits
Flammability
Fire hazard
CONTENTS UNDER PRESSURE. In a fire or if heated, a pressure increase will occur and the
container may burst. Bursting aerosol containers may be propelled from a fire at high speed.
N
on-flammable.
Fire-Fighting
Procedures
Use dry chemical, CO
2
, water spray (fog) or foam.
Section 5. Fire Fighting Measures
Spill Clean up
Spills are unlikely due to packaging.
Section 6. Accidental Release Measures
Handling
Storage
Avoid contact with eyes. Avoid prolonged contact with eyes, skin and clothing. Avoid breathing vapors, spray or
mists. Use only with adequate ventilation. Wash thoroughly after handling. Store and use away from heat, sparks,
open flame or any other ignition source.
CONTENTS UNDER PRESSURE. Do not puncture or incinerate container. Store below 120°F (49°C). Keep
container in a cool, well-ventilated area. Keep out of the reach of children.
Section 7. Handling and Storage
Product name Exposure limits
Butyl Cellosolve; Ethylene Glycol Monobutyl Ether;
2-Butoxyethanol
OSHA PEL 1989 (United States, 3/1989). Absorbed through skin.
TWA: 25 ppm 8 hour(s).
TWA: 120 mg/m³ 8 hour(s).
NIOSH REL (United States, 6/2009). Absorbed through skin.
TWA: 5 ppm 10 hour(s).
TWA: 24 mg/m³ 10 hour(s).
ACGIH TLV (United States, 2/2010).
TWA: 20 ppm 8 hour(s).
OSHA PEL (United States, 6/2010). Absorbed through skin.
TWA: 50 ppm 8 hour(s).
TWA: 240 mg/m³ 8 hour(s).
Butane
OSHA PEL 1989 (United States, 3/1989).
TWA: 800 ppm 8 hour(s).
TWA: 1900 mg/m³ 8 hour(s).
NIOSH REL (United States, 6/2009).
TWA: 800 ppm 10 hour(s).
TWA: 1900 mg/m³ 10 hour(s).
ACGIH TLV (United States, 2/2010).
TWA: 1000 ppm 8 hour(s).
acetone
ACGIH TLV (United States, 2/2010).
TWA: 500 ppm 8 hour(s).
TWA: 1188 mg/m³ 8 hour(s).
STEL: 750 ppm 15 minute(s).
STEL: 1782 mg/m³ 15 minute(s).
OSHA PEL 1989 (United States, 3/1989).
TWA: 750 ppm 8 hour(s).
TWA: 1800 mg/m³ 8 hour(s).
Section 8. Exposure Controls/Personal Protection
Page: 2/5