User`s guide

39
Advanced Menu (continued)
Chapter 3 - Using SETUP
1st COM Port
When 1st COM Port (COM A) is set to Auto, the system will
automatically set the interrupt and IRQ for that port. Otherwise this
option allows you to choose (from a list) the interrupt and I/O address of
the 9-pin serial port.
Default: Auto.
2nd COM Port
When 2nd COM Port (COM B) is set to Auto, the system will
automatically set the interrupt and IRQ for that port. Otherwise this
option allows you to choose (from a list) the interrupt and I/O address of
the 25-pin serial port.
Default: Auto.
LPT Port
Sets the parallel port designation. This allows you to specify the parallel
port address and IRQ, which otherwise are factory set.
Default: Auto.
LPT Mode
Allows you to set the parallel port communication mode to match the
capabilities of your parallel port device. Settings: Unidirectional,
Bidirectional or Enhanced.
Default: Unidirectional.
Floppy Disk Controller
Configures the on-board floppy disk controller to Primary, Secondary, or
Disabled.
Default: Primary.