User`s guide

34
Main Menu Options
System Time
Sets the real-time clock, using a 24-hour format. During the power-up
sequence, the real time is read and saved in memory for use by the
operating system. After boot up, the operating system updates the system
time.
System Date
Sets the real-time date for month, day, and year. During the power-up
sequence, this information is read and saved in memory for use by the
operating system to determine the current date. After completing the
power-up sequence, the operating system updates the current date.
Daylight Savings
Adjusts system clock for daylight savings time. Default: Enabled.
Diskette Drive A:
Specifies the size and capacity of the floppy-disk drive installed as drive
A. Options are: 360K, 720K, 1.2M, 1.44M, and 2.88M.
Diskette Drive B:
Specifies the size and capacity of the floppy-disk drive installed as drive
B.
IDE Adapters (Four Provided)
Each of the four IDE Adapter subsections allows you to view and change
configurations of the IDE devices attached to your on-board IDE Hard
Drive connectors, J7 and J8. The IDE Adapter subsections list the IDE
devices that are currently installed. Your Primary hard drive (J7) is listed
as IDE Adapter 0 Master. You can attach a second hard drive to the same
cable as IDE Adapter 0 Slave, then two more devices on the Secondary
connector (J8) as IDE Adapter 1 Master, or IDE Adapter 1 Slave. The
following page describes the contents of each IDE Adapter subsection.
Note: If you attach two drives to a single drive cable, it doesn’t matter whether or not
the Master drive is connected to the end connector. Just be sure that one drive
is configured as Master and the other drive is configured as Slave.
Chapter 3 - Using SETUP