User`s guide

41
Chapter 3 - Battery and Power Management
Setting Power Management
Your system can operate in one of three power modes: normal,
power saving, or suspend.
Normal Mode
The system runs at the speed specified in SETUP (Full, Slow).
Power Saving Mode
Power saving mode reduces power to the hard drive after
several minutes of inactivity. You can set the amount of time the
system should wait before powering down the hard drive. If no
activity is detected during the period of time specified in
SETUP, the system switches to the power saving mode. See
Chapter 5, Using SETUP, for more information about setting
the power saving configuration.
Suspend Mode
In suspend mode, system clock speed is lowered to 0 MHz and
the green power/suspend light blinks continuously. Push and
hold the suspend/resume button for about one second to enter or
cancel suspend mode.
Warning!
While in Suspend Mode, the system still draws a small amount of power. If you leave
your system in Suspend mode for a long time, the battery will eventually run down.