Instruction manual

B. The film holder can be taken out for film loading upon opening

the back cover.

C. There are two spool holders on the film holder. The top one is for

the fresh film spool while the bottom one is for the empty take-up

spool. The left-side shaft of the spool holder can be opened by push-

ing the fresh film spool outward in the arrow-indicated "A" direction.

Then, insert the right end of the spool on to the right-side shaft,

which is fixed, and then close the left-side holder (shaft), which will

engage the spool.

* The spool holders on the left side will be locked securely when the

back cover is closed.

D. After loading the fresh film spool properly, draw out the leading

end of the film and turn it across the film pressure plate (as illustrat-

ed). Run it down and turn it over to the take-up spool. Insert the lead-

ing end into the slit of the take-up spool and wind slightly until

securely engaged.

* The inside black surface of the leader must face out when running

across the pressure plate.

E. Rotate the film back winding crank on the right side of the film

insert in the direction indicated by the arrow, while checking the

advancing film. When the starting point, or arrow mark, is aligned

with the triangular start-mark on the top left side of the film insert,

stop rotation.

5. Film Loading

A. To open the back cover, squeeze the left and right back cover

release buttons, in the arrow-indicated directions, at the same time

and the back cover will open.