Instruction manual

26
If the equipment is not being used for a long period of time, store everything in tin-lined
containers, with plenty of desiccant, such as silica gel. Finally store the equipment in a cool,
dry and well-ventilated (but not windy) place.
Do not over tighten when using a longer-than standard tripod screw, as you may damage
the body.
Both the main camera body and lens must be in the "cocked" condition to attach or remove
the lens. In other words, when "cocked" the cocking pin of the lens will be set between the
red band and green dot, while the cocking pin of the main body mount will be set to the
green-colored dot. When not set in the above manner, the cocking pin of the detached lens
can be set by moving it manually, while the cocking pin of the main body mount will be set
by revolving the film-winding crank.
Although exposure compensation up to ±2 stops is possible at 1/3rd increments, there are
limits on the movement of the exposure compensation dial, as indicated in the table.
Film Speed Exposure
Compensation Range
ISO 25 -2 :: -1 :: 0
ISO 50 -2 :: -1 :: 0 :: +1
ISO 100-1600 -2 :: -1 :: 0 :: +1 :: +2
ISO 3200 -1 :: 0 :: +1 :: +2
ISO 6400 0 :: +1 :: +2
30. Care of the SQ-Ai
Always protect the lens with its cover, when carrying the camera.
Upon attaching the film back, always pull out the dark slide from its slit.
Protect your camera from impact and vibrations, too.
Protect your camera from temperature changes, which can result in moisture condensation,
frost, etc., inside the body, leading to rusting of metallic parts.
Clean the camera and lens very carefully after using it outdoors in wet weather or at the
seashore.
Wipe the camera carefully with a well-wrung damp cloth, using fresh water, if the exterior is
affected by salty air. Then, wipe it dry with a soft, dry cloth. If necessary, send it out for a
quick inspection at an authorized repair station.