Specifications

13
C. The shutter cannot be released in the following cases:
1. Shutter release button is locked.
2. Dark slide is inserted.
3. Film winding crank has not been rotated fully. (same when the exposure counter is
still between "S" and "1".)
4. Shutter is not cocked.
5. Lens is not properly attached.
6. Lens release button is being depressed.
7. All frames (15 on 120 roll film and 30 on 220 roll film) have been exposed already.
*If the film winding crank is rotated before completion of the preset shutter speed, such as
when a slow shutter speed is being used, the frame will be underexposed and image streak-
ing in the frame may occur as well. Also, although the shutter will not be released on the
next frame, there may be leakage of light onto that frame.
A. Depress the shutter release button with the ball of the finger.
Press all the way in with a smooth and gentle action.
* A red-colored LED will flash briefly in the left-rear corner of the
focusing screen area, when the shutter is released. This will indicate
that the lens shutter has closed and the exposure is complete, and
should be noted when using a slow shutter speed.
B. Safety Lock- The safety index on the shutter release button can be
rotated to three positions for obtaining different shutter function.
The settings are directly left, 45 degrees up from the side position
and directly above, which have different safety lock functions.
* The safety lock index should be set 45 degrees diagonally when
using Motor Winder Ei.
11. Shutter Release Button