User's Manual

Page 9
Handlebar
Console
Clamp
Mounting Screws
INSTALLATION OF THE PILOT
THE CADENCE METER CAN ONLY BE INSTALLED ON A
LEMOND REVMASTER BIKE.
To install the meter, the following tools are needed:
• Philips Screwdriver
• 4-mm Hex Key (supplied)
Console Installation:
1. Ensure that the batteries are installed in the console and
the console turns on.
2. Spread the bottom of the console clamp apart and
clamp itback together over the top center of the handle
bar.
3. Insert a mounting screw into each hole and use a
4-mm hex key to tighten the screws.