User's Manual

ASSEMBLY
BODY
BIKE
®
INDOOR CYCLE
PEDALS
1: Place the right pedal arm
with the socket pointing
upwards, see gure 11.
2: Add resistance on the brake,
so the pedal arm is unable to
rotate, see gure 12.
3: After tightening by hand,
use a 15mm pedal wrench to
tighten the pedal completely
(45Nm).
Figure 12
Figure 13
Figure 11
Please note
- the pedals are marked
with R for Right and L for
Left side.
- the pedals should always
be screwed on in the
direction of the handlebar,
see gure 13.
- make sure that the hole
in the pedal arm is greased
when mounting the pedal.
- start mounting the
pedal by hand as tools
will tighten the pedal at a
wrong angle.
BOTTLE HOLDER
1: Mount the bottle holder at the
top of the handlebar, see gure 9.
Add one or two rubber rings if the
bottle holder is not rmly xed.
SADDLE
1: Place the saddle in the track on
the seat post.
2: Secure the saddle with the
remaining adjustment handle, see
gure 10. To fasten the saddle to
the adaptor and adjust the tilt of
the saddle, use a 14mm wrench
on the bolt marked with an A on
gure 10.
9
ASSEMBLY
BODY
BIKE
®
INDOOR CYCLE
9