User's Manual

Figure 10
WASHER
A
Figure 3
WASHER
Figure 9
HANDLEBAR
1: Place the handlebar on top of
the front post.
2: Screw an adjustment handle
(size 32mm) clockwise into
the socket from underneath
the post, see gure 3. Fix the
handlebar completely to the
front post by tightening the
adjustment screw on the right
side of the handlebar.
CONSOLE
Figure 4
RUBBER PAD
REMOVE
Add rubber rings if needed
Figure 5 Figure 6
Figure 7 Figure 8
Please note:
The console is set for km and kg
as default. If preferred change
to miles and lb before mounting
the console, see page 18.
1: Remove the small plastic strip on
the back of the console, see gure
4. Make sure batteries are correctly
inserted.
2: Mount the console on the
handlebar mount by using the 3
screws, see gure 5. Rubber pad
should face matt side outwards.
3: Press the handlebar mount onto
the handlebar, see gure 6.
4: Adjust the angle to your preferred
view of the console, see gure 7.
5: Tighten the two screws on the
mount, see gure 8.