User's Manual

UNPACKING THE PALLET
1: Begin by opening the top of
the box.
2: Remove all the unmounted
parts.
3: Flatten the box on the oor
next to the pallet.
4: Loosen the two screws
mounting the rst cycle to the
pallet.
5: Lift the cycle o the pallet
and place it on the attened
box to spare your oor from
getting marks.
BOTTOM FRAME
1: Arrange the bottom frames
parallel on the oor next to the
cycle with the correct mounting
distance between them, see
gure 1. On the front bottom
frame, the transport wheels
should point forward.
2: Take hold of the front post
and seat post and lift the cycle
onto the bottom frames, see
gure1. Ensure that the holes
in the frame match the holes in
the bottom frames.
3: Put on the spring lock washer
and the cap nut and tighten
by using a 13mm wrench, see
gure 2.
Please note
Do not overtighten the nuts.
They should only be hand
tight.
4: Unscrew the rubber feet
a little. Place the cycle in the
correct position. Turn them up
and down until the cycle stands
properly and it is level.
Figure 1
BACK
BOTTOM
FRAME
FRONT
BOTTOM
FRAME WITH
WHEELS
POINTING
FORWARD
LIFT
Figure 2
SPRING LOCK
WASHER
CAP NUT
Please note
The cycle is precoded to a
console. Match the number
on the hanger to the
number on the box.
MATCH NUMBERS
ASSEMBLY
BODY
BIKE
®
INDOOR CYCLE
7