User's Manual

The navigation line at the bottom
of the screen will show you what
screen you are on and if you are
in scan mode. In scan mode the
console automatically changes
between the rst two screens. The
console is in scan mode when the
line underneath the word ‘scan’ is
on and the line above ‘scan 1 2’ is
on.
A line will also appear under the
screen number which is currently
shown,
see gure 41.
End scan mode:
Press W or X and the console will
end scan mode. X takes you to
screen 1 and W takes you to screen
5, see gure 42.
Enter scan mode:
Keep pressing W or X until the line
under scan turns on, see gure 42.
Navigate between screens:
UseW or X, see gure 42.
Screen 1
[RPM, %MAX HR, %MAX WATT]
The screen shows the values
relative to your maximum values.
This is the data you will most likely
use during training.
Screen 2
[RPM, HR, WATT]
This screen holds the absolute
values.
23451SCAN
23451SCAN
RPM
%
MAX
HR
%
MAX
WATT
234
5
1SCAN
RPM
HR
WATT
Figure 42
SCAN
MODE
Figure 41
The console is in scan mode
On screen 1
NAVIGATION, SCAN AND THE FIVE SCREENS