User's Manual

3: If there is no heart rate transmitter
paired, the pairing will start
automatically and the display will
look like gure 34. If a heart rate
transmitter is already paired, the
display will look like gure 35.
Press F to maintain this pairing and
continue to next setting, see gure
37, or press W or X to start new
pairing.
4: Lean forward to get your heart
rate transmitter as close to the
CODE
HR PAIRING
PAUSE
ACCEPT
ADJUST
QUIT
HR PAIRING
PAUSE
ACCEPT
ADJUST
QUIT
Figure 37Figure 36Figure 35Figure 34
Press F to accept
and continue
Press XE to
accept and end
Press W or X to
start new pairing
Running segments
until pairing is
complete
AGE OR MHR AND WEIGHT
Press F to enter setting mode. If you
are wearing a heart rate transmitter,
follow guidance on page 20 to pair
Press XE to
accept and end
setting mode
Press F to accept
and continue to
OFYUTFUUJOH
Press W or X to
increase/decrease
bottom of the console as possible,
see gure 36. The display will run
segments in 0 shapes until the code
is registered. When the pairing is
nished the display will look like
gure 35. Press F to maintain this
pairing and continue to next setting.
Press W or X to start new pairing.
it. If not, press F to continue without
heart rate transmitter. Enter your
age or MHR and weight as described
on gure 37.
WATT TEST
If you already know your relative
VO2 max, use the arrows to enter it
and press F or XE to accept and end
setting mode. If you do not know it,
you can do a watt max test. Please
follow the guide below.