User's Manual

2: Choose the model Po. Use WX
to change. Press F to continue
directly to set units (go to step 3) or
press XE to start reconnecting to
the control box. For reconnecting
automatically press XE again and
pedal a few times to activate the
control box. The console will run
segments until the control box
code is shown. For reconnecting
manually long press XE. Use WX
to enter code and F to accept. The
control box code is written on the
black/white label inside the control
box battery hatch.
3: Set units (kg or Lb) by using WX.
Press F to accept.
ACCEPT
ADJUST
ACCEPT
ADJUST
ACCEPT
ADJUST
ACCEPTACCEPTACCEPT
PEDAL
PRESS XE FOR AUTO SEARCH
LONG PRESS XE FOR MANUAL
END DEFAULT
SETTING MODE
INDIVIDUAL
LOAD CELL NO.
DO NOT CHANGE.
CHANGE LOAD
CELL CAL. NO.
(ONLY WHEN
REPLACING
LOAD CELL)
Figure 32
TIPS AND INFORMATION
Heart rate
The BODY BIKE Performance
Console is able to receive data
from several brands of heart rate
transmitters. Some connections
may be more fragile than others.
Move the bikes further apart if you
Please note:
The console will
display ‘Err’ if it is not able to leave
default setting mode because it
failed to connect to the control
box. Make sure the control box
code is correct and pedal a few
times to activate the control box.
4: Set units (km or miles) by using
WX. Press F to accept.
5: The next number shown on
the display will be the load cell
calibration number. Do not
change this number unless you
have replaced the load cell. Move
between options by using WX.
Accept and quit by pressing F.
Please note: You can retain the
load cell calibration number
from BODY BIKE if needed.
Please write an email to info@
body-bike.com and state the
bike’s serial number (on the
metal plate on the top cover)
and the two numbers on the
right side of the load cell.