User's Manual

4: Use a 10mm wrench to
tighten the counter bolts (3). On
the right side, the tool should
be pulled downwards and on
the left side upwards to tighten.
5: The belt should be tightened
to approximately 125 kg/229
Hz. To measure this, a special
device can be bought at your
local BODY BIKE Distributor.
6: Tighten the counter bolt (2)
on both sides of the cycle again.
Please note:
The belt should be equally
tightened on both sides.
The ywheel should be
parallel with the long main
side member.
POLY-V BELT
If the belt does not catch hold
of the ywheel, it is time for it to
be tightened.
1: Remove both service hatches
see gure 15 on page 10.
2: Loosen the bolts (1) on both
sides of the cycle with a 19mm
wrench, see gure 29.
3: Loosen the nuts (2) on the
counter bolt on both sides of
the cycle using a 10mm wrench,
see gure 30.
(1)(2)(3)
Figure 30 MAGNET PATHFigure 31
7: Tighten the bolt(1) again on
both sides of the cycle.
8: Check that the magnet is
still passing the control box in
front of the arrow printed on
the back side of the control box,
see gure 30. If not, loosen the
screws holding the control box
to the ange and slide the box
in front of the magnet. Tighten
the two screws by hand.
9: Follow the steps in the
section “Calibration” to ensure
accurate readings, see page 15.
MAINTENANCE
BODY
BIKE
®
INDOOR CYCLE
16