Operation Manual

- 19 -
1. Switch the remote control to【User Mode】。
2. Select Group:Press any button of 「」、「 」、「 <」、「 >」to move cursor [ ] to
the target group channels G1 ~ G4 which needs to be executed. The
ZEN16SA remote control provides up to 4 groups to perform.
3. Enter group setting:Press【Enter】for 3 seconds to enter group setting.
Set Group Control
Press【Enter】
for 3 sec.
Select group
Select target group,then the
selected group channel is flash.
Press any of them
to move cursor
Enter group setting
Press
【
Enter
】
for 3 seconds
until the group icon G2~G4
disappear, and G1 is flash.