User Guide

Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
98
This control will have associated a dedicated object for the indicator (“[Ci] Room State
Indicator”), which is automatically updated after the control order is sent and when values
are received from the bus.
2.2.2.1.4 CLIMATE CONTROL
This category covers a set of functions related to the climate control. The available options
for Function (and for the dependent parameters) are as follows:
2.2.2.1.4.1 Temperature Setpoint
This function permits controlling the temperature setpoint of an external thermostat by
means of a two-button box and of the parameters enabled to that effect: “[Ci] (Climate)
Setpoint Temperature Control” for the control and “[Ci] (Climate) Setpoint
Temperature Indicator” for the status. It is also possible to enable a real temperature
indicator that will be updated through the object “[Ci] (Climate) Real Temperature
Indicator”.
The box itself will permanently reflect the value in ºC o ºF of the status object, whose value
gets automatically updated after sending control orders (that is, after pressing the buttons),
being even possible to receive values from the bus, for example, from the corresponding
setpoint status object from the external thermostat.
Therefore, after every press on the temperature increment button, the bus will be sent
(through the control object) a certain value, progressively increased on every button press
until the parameterisable maximum setpoint value has been reached. Analogously, after
every press on the temperature decrement button, the bus will be sent a progressively
decreased value until the parameterisable minimum setpoint value has been reached.