User Guide

Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
95
2.2.2.1.3.7 Shutter
Shutter control permits sending move up and move down ("[Ci] Shutter - Move”) or stop
(“[Ci] Shutter – Stop/Step”) to control a shutter actuator connected to the bus by pressing
the buttons in the box. In addition, the box will contain an indicator that will permanently
show, as a percentage, the value of the status object (“[Ci] Shutter Position”).
Figure 83 2-Buttons Control - Shutter
Type: set the desired behaviour for the buttons:
➢ [
Standard]: a long press will make the device send to the KNX bus an order
to start moving the shutter (upwards or downwards, with the top or bottom
button respectively), while a short press will make it send a stop order (or
step up / step down).
➢ [Hold & Release]: as soon as the button is held, the device will send the
KNX bus an order to start moving the shutter (upwards or downwards, with
the top or bottom button respectively). Once the button is released, it will
send an order to stop the shutter.
Show Percentage indicator [disabled/enabled]: enables or disables the shutter
position indicator (in percentage) in the box.
Additionally, the shutter control will have the percentage object "[Ci] Shutter Positioning
(Only Schedulers and Macros)" which will be used by schedulers and macros for a
precise regulation of the shutter.