User Guide

Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
90
2.2.2.1.3.2 Switch + Indicator
In the same way the previous control, when pressing in any of the controls configured as
switch, Z70 v2 will send the parameterised binary value to the bus through the object "[Ci]
Switch". However, the indicator is independent and will only be updated according to the
value received by the dedicated object.
Figure 77. 2-Buttons Control - Switch + Indicator
Action [Bottom = 0; Top = 1 / Top = 0; Bottom = 1]: sets the value to be sent
when pressing each of the two buttons.
Indicator Type [Counter / Scaling / Float / Temperature]: sets the indicator type.
According to the selected indicator the objects. The range of values allowed in
each case and the name of the corresponding object are listed in the table.
Function
Size
Sign
Range
Related Object
Counter
1 Byte
Unsigned
0 – 255
[Ci] 1-Byte Unsigned Int Indicator
Signed
-128 – 127
[Ci] 1-Byte Signed Int Indicator
2 Bytes
Unsigned
0 – 65535
[Ci] 2-Byte Unsigned Int Indicator
Signed
-32768 – 32767
[Ci] 2-Byte Signed Int Indicator
Scaling
1 Byte
0 – 100
[Ci] Percentage Indicator
Float
2 Bytes
-671088.64 – 670433.28
[Ci] 2-Byte Float Indicator
Temperature
1 Byte
-99 – 199
[Ci] Temperature Indicator
Table 5. Numerical indicators – Switch + Indicator
Units: permits specifying the measuring units of the displayed value.
Note: