User Guide
Table Of Contents
- Contents
- Document updates
- 1 Introduction
- 2 Configuration
- 2.1 General
- 2.2 Display
- 2.3 Inputs
- 2.4 Thermostat n
- ANNEX I. Video Intercom Operation
- ANNEX II. Internal Call Operation
- ANNEX III. Remote Control via IP
- ANNEX IV. Graphs
- ANNEX V. Differences with Z50 / Z100
- ANNEX VI. Communication Objects
Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
89
2.2.2.1.3 2-BUTTON CONTROL
The box configured with this control type will have a button at the right and a state indicator.
In addition, through Function parameter, it will be possible to select the specific function
that the control will perform.
Figure 75 2-Button Control (Box)
2.2.2.1.3.1 Switch
When the user touches the buttons in the box, a binary value will be sent through the “[Ci]
Switch” object, while the status object “[Ci] Binary Indicator” will determine the icon or
text shown in the box. The indicator will be updated automatically after each control order,
and will also be able to receive values from the bus.
Figure 76. 2-Buttons Control - Switch
Action [Bottom = 0; Top = 1 / Top = 0; Bottom = 1]: sets the value to be sent
when pressing each of the two buttons.
Indicator Type [Icon / Text]: allows selecting whether the status represented by
each indicator value will be text type or icon type.