User Guide
Table Of Contents
- Contents
- Document updates
- 1 Introduction
- 2 Configuration
- 2.1 General
- 2.2 Display
- 2.3 Inputs
- 2.4 Thermostat n
- ANNEX I. Video Intercom Operation
- ANNEX II. Internal Call Operation
- ANNEX III. Remote Control via IP
- ANNEX IV. Graphs
- ANNEX V. Differences with Z50 / Z100
- ANNEX VI. Communication Objects
Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
86
Figure 71. 1-Button Control - Scene
Action [Run / Run and Save]: sets whether the device will only send scene
execution orders (after a short press) or if it will be possible, to send scene save
orders (after a long press).
Scene Number [1…64]: scene value to be sent.
Object to Use [General Scene Object / Individual Box Scene Object]: specifies
whether the scene value will be sent through the object "[General] Scenes:
Send" or through the individual object "[Ci] Scene: Send".
2.2.2.1.2.5 Constant Numerical Controls
When the functions “Counter Constant”, “Scaling Constant” or “Float Constant” is assigned
to a control, the button in the box will react to user presses by sending a certain numerical
value. This numerical value will depend on the constant control type selected to the box.
Figure 72. 1-Button Control – Constant Numerical