User Guide
Table Of Contents
- Contents
- Document updates
- 1 Introduction
- 2 Configuration
- 2.1 General
- 2.2 Display
- 2.3 Inputs
- 2.4 Thermostat n
- ANNEX I. Video Intercom Operation
- ANNEX II. Internal Call Operation
- ANNEX III. Remote Control via IP
- ANNEX IV. Graphs
- ANNEX V. Differences with Z50 / Z100
- ANNEX VI. Communication Objects
Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
85
Different objects are used to send values for short and long pulsations: "[Ci] Two
objects - Short Press" and "[Ci] Two objects - Long Press", respectively.
If the option chosen is “Send 0” or “Send 1”, the object "[Ci] Two objects -
Indicator" will appear for the box indicator, which is automatically updated after
the control order is sent and when values are received from the bus.
Long Press Threshold Time [4…6…50] [ds]: sets the minimum time the user
should hold the button in order to consider it a long press.
2.2.2.1.2.3 Hold & Release
This control function allows the user to configure sending a binary value on pressing and
a different binary value on releasing the button. In addition, this control will have
associated a dedicated object for the indicator (“[Ci] Binary Indicator”), which is
automatically updated after the control order is sent and when values are received from
the bus.
Figure 70. 1-Button Control - Hold & Release
Action on Hold / Release [Send 0 / Send 1]: permits setting what value will be
sent to the bus through the objects "[Ci] Hold & Release", and before which
events.
2.2.2.1.2.4 Scene
When this function is assigned to a control, the box button will react to the different pulses
by sending a certain scene value.