User Guide
Table Of Contents
- Contents
- Document updates
- 1 Introduction
- 2 Configuration
- 2.1 General
- 2.2 Display
- 2.3 Inputs
- 2.4 Thermostat n
- ANNEX I. Video Intercom Operation
- ANNEX II. Internal Call Operation
- ANNEX III. Remote Control via IP
- ANNEX IV. Graphs
- ANNEX V. Differences with Z50 / Z100
- ANNEX VI. Communication Objects
Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
83
2.2.2.1.1.4 Text
The box will show the text received through the communication object “[Ci] Text
Indicator”.
Figure 66. Indicator - Text.
2.2.2.1.2 1-BUTTON CONTROL
The box configured with this control type will have a button (at the top right or throughout
the box, see section 2.2.2) and a state indicator. In addition, through Function parameter,
it will be possible to select the specific function that the control will perform.
Figure 67 1-Button Control (Box).
2.2.2.1.2.1 Switch
The button of the box will react to user presses by sending a binary value to the bus
through the “[Ci] Switch” object. In addition, this control will have associated a dedicated
object for the box indicator (“[Ci] Binary Indicator”), which is automatically updated after
the control order is sent and can also receive values from the bus.