User Guide
Table Of Contents
- Contents
- Document updates
- 1 Introduction
- 2 Configuration
- 2.1 General
- 2.2 Display
- 2.3 Inputs
- 2.4 Thermostat n
- ANNEX I. Video Intercom Operation
- ANNEX II. Internal Call Operation
- ANNEX III. Remote Control via IP
- ANNEX IV. Graphs
- ANNEX V. Differences with Z50 / Z100
- ANNEX VI. Communication Objects
Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
76
ETS PARAMETERISATION
Figure 58. Configuration Page n
This screen contains the following parameters:
Title: text field that identifies each of the enabled pages. In addition, this field
allows changing the name of the tab in ETS left menu, as shown in the Figure
58.
➢ Use this Text in the Device [disabled/
enabled]: allows the text to be used
as the page title in the device.
Icon [Kitchen]: sets the icon that will represent the page in the Menu page. It
could be selected from two available lists [Menu / General].
➢ “Menu” is a list of the most common icons that are configured in the main
menu.
➢ “General” is a list of all available icons. At the end of the list, customised
icons, that must have been previously imported, can be selected (see
section 2.1.11.4).
Note: a list with all icons available can be found in document “Z70 v2 Icon list”, available
at www.zennio.com.
Automatic Page Shaping [disabled/enabled]: enables to choose whether the
controls should be automatically or be displayed as a static grid.
Note: if automatic page shaping is enabled, grouping of 2x2 cells is not possible.