User Guide
Table Of Contents
- Contents
- Document updates
- 1 Introduction
- 2 Configuration
- 2.1 General
- 2.2 Display
- 2.3 Inputs
- 2.4 Thermostat n
- ANNEX I. Video Intercom Operation
- ANNEX II. Internal Call Operation
- ANNEX III. Remote Control via IP
- ANNEX IV. Graphs
- ANNEX V. Differences with Z50 / Z100
- ANNEX VI. Communication Objects
Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
75
When enabling the mode, the value ‘1’ is sent through the object “[VoIP] “Do Not
Disturb” Mode” and when the timing expires it is sent the value ‘0’. It is also
possible to stop the countdown disabling the mode (by manually or through the
communication object).
2.2.1.3 PAGE N
Z70 v2 has up to twelve general purpose pages that can be enabled from the "Pages" tab.
Thus, a new tab called Page n will be displayed for each of the n enabled pages.
Inside each page, the desired controls can be placed as boxes arranged in order,
according to the parameters for each page. In addition, larger boxes can be created by
grouping 4 boxes, with a format of 2x2. To make this type of grouping it is necessary to
configure the page as shown in Figure 56.
Figure 56. 2x2 Boxes Configuration
Figure 57. 2x2 Box Visualization