User Guide
Table Of Contents
- Contents
- Document updates
- 1 Introduction
- 2 Configuration
- 2.1 General
- 2.2 Display
- 2.3 Inputs
- 2.4 Thermostat n
- ANNEX I. Video Intercom Operation
- ANNEX II. Internal Call Operation
- ANNEX III. Remote Control via IP
- ANNEX IV. Graphs
- ANNEX V. Differences with Z50 / Z100
- ANNEX VI. Communication Objects
Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
74
Figure 55. Configuration page - VoIP calls
Video Intercom Ringtone [disabled/enabled]: box to change the melody to be
played when receiving a call from an external unit.
Internal Call Ringtone [disabled/enabled]: box to change the melody to be
played when receiving a call for an internal unit.
Ringtone Volume [disabled/enabled]: enables the box to modify the calls tone
volume.
SIP ID/IP Address/Gateway [disabled/enabled]: information box showing the
ID, IP address and gateway, as configured in “IP Configuration” tab (see section
2.1.12)
“Do Not Disturb” Mode: Enabling [disabled/enabled]: checkbox to enable or
disable the do not disturb mode. When enabled, incoming calls will not be
received. However, in case of Video Intercom functionality, they will be
registered in the call log.
When enabling the mode, the value ‘1’ is sent through the object “[VoIP] “Do Not
Disturb” Mode” and when disabling it is sent the value ‘0’.
Note: if do not disturb mode is enabled during a call, the call will go through
normally and the mode will be activated when the call finishes.
“Do Not Disturb” Mode: Timing [disabled/enabled]: this box set the time that
the do not disturb mode will be active. A time 0 will activate this mode indefinitely.