User Guide
Table Of Contents
- Contents
- Document updates
- 1 Introduction
- 2 Configuration
- 2.1 General
- 2.2 Display
- 2.3 Inputs
- 2.4 Thermostat n
- ANNEX I. Video Intercom Operation
- ANNEX II. Internal Call Operation
- ANNEX III. Remote Control via IP
- ANNEX IV. Graphs
- ANNEX V. Differences with Z50 / Z100
- ANNEX VI. Communication Objects
Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
71
Figure 51. Configuration Page. Device.
Programming Button [disabled/enabled]: control/indicator that shows the
status of the Prog./Test LED of the device. In particular, it permits
entering/leaving the programming mode as by pressing the actual programming
button of the device.
Reset [disabled/enabled]: enables or disables the box to perform a reset on the
device, by pressing more than 3 seconds the button:
➢ Reset Type:
• [Parameters Reset]: similar to restoring the device to the just-
parameterised state.
• [Application Reboot]: simple device reset, with no data loss.
• [Parameters Reset and Application Reboot]: the above two, combined.
KNX [disabled/enabled]: indicator that shows the individual address of the
device.
Program Version [disabled/enabled]: indicates the downloaded firmware and
program version.
IP/MAC [disabled/enabled]: indicates the IP and MAC direction.
Serial number [disabled/enabled]: indicates the device serial number.
Moreover, for all these controls, the following parameter can be configured: