User Guide
Table Of Contents
- Contents
- Document updates
- 1 Introduction
- 2 Configuration
- 2.1 General
- 2.2 Display
- 2.3 Inputs
- 2.4 Thermostat n
- ANNEX I. Video Intercom Operation
- ANNEX II. Internal Call Operation
- ANNEX III. Remote Control via IP
- ANNEX IV. Graphs
- ANNEX V. Differences with Z50 / Z100
- ANNEX VI. Communication Objects
Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
70
Note: the voice control and device pairing boxes will always be visible when the
Remote Control parameter is enabled and hidden when the Remote Control
parameter is disabled.
Moreover, for all these controls, the following parameters can be configured:
Label: text that will appear to identify the box.
Protect [No / Yes] / [No / Level 1 / Level 2]: exactly the same as the page
protection explained above, but for the boxes.
Object to Show/Hide Box [disabled/enabled]: when this option is enabled, a
new 1-bit object appears (“[Config.][Bi] Show/Hide Box”) that allows hiding /
showing the box through the KNX bus.
2.2.1.2.1 Device
Z70 v2 configuration page, if Device is enabled, will display a button allowing access to
several controls and indicators with device-specific information:
Figure 50. Device.
ETS PARAMETERISATION
After enabling the Device from “Configuration Page” screen (see section 2.2.1.2), a new
tab will be incorporated into the tree on the left.