User Guide
Table Of Contents
- Contents
- Document updates
- 1 Introduction
- 2 Configuration
- 2.1 General
- 2.2 Display
- 2.3 Inputs
- 2.4 Thermostat n
- ANNEX I. Video Intercom Operation
- ANNEX II. Internal Call Operation
- ANNEX III. Remote Control via IP
- ANNEX IV. Graphs
- ANNEX V. Differences with Z50 / Z100
- ANNEX VI. Communication Objects
Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
69
Alarm confirmed, but not finished
Alarm finished and confirmed
Table 2. Alarm Log Icons
This centralised file may be useful when the user needs to check the status of a
set of alarm controls distributed across several pages.
Figure 49. Alarm Log
To delete the record, press and hold the button , at the bottom right of the
window for more than 3 seconds.
Note: For information on alarms, see section 2.2.2.1.5.4.
VoIP Calls [disabled/enabled] (License required): enables or disables the “VoIP
Calls” tab in the left menu. For more information, see section 2.2.1.2.3.
Device Pairing [enabled] (License required): button to access to the pairing
function, which must be executed with each device desired to control the Z70 v2
remotely. For more details, please refer to ANNEX III. Remote Control via IP.
Voice Control [enabled] (License required): enable the box to activate or
deactivate voice control function. Please refer to the user manual “ZenVoice”
(available in the Z70 v2 product section at the Zennio homepage,
www.zennio.com) for detailed information about the functionality and the
configuration.