User Guide
Table Of Contents
- Contents
- Document updates
- 1 Introduction
- 2 Configuration
- 2.1 General
- 2.2 Display
- 2.3 Inputs
- 2.4 Thermostat n
- ANNEX I. Video Intercom Operation
- ANNEX II. Internal Call Operation
- ANNEX III. Remote Control via IP
- ANNEX IV. Graphs
- ANNEX V. Differences with Z50 / Z100
- ANNEX VI. Communication Objects
Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
68
• [No / Yes]: sets whether the page is password-protected at level 1 or
without a password.
➢ Two Levels:
• [
No / Level 1 / Level 2]: sets the level of security to access the configuration
page.
Time/Date [disabled/enabled]: if enabled, the date and time of the device can
be set directly from the user interface:
Figure 48. Time and date.
Device [disabled/enabled]: enables or disables the “Device” tab in the left menu.
For more information, see section 2.2.1.2.1
Profile [disabled/enabled]: enables or disables the “Profile” tab in the left menu.
For more information, see section 2.2.1.2.2
Probe Calibration [disabled/enabled]: enables or disables the box to configure
the offset of the internal temperature probe.
Alarm Log [disabled/enabled]: enables or disables the alarm log box that
provides access to the log file where alarm events are incorporated, in reverse
chronological order, with the name, time and date of every alarm event will being
shown. In addition, the log will show the current status of each of them:
Alarm State
Icon
Alarm active
Alarm finished, but not confirmed