User Guide

Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
61
Time to Activate the Welcome Object [30...65535][s] [1…65535][min/h] : sets
the minimum time that should elapse after the last button touch (or presence
detection, when the proximity sensor is enabled) before the next one triggers the
execution of the welcome back function.
Send Object Trigger [Press Button / Detect Presence]: sets whether the
welcome back object is sending after a touch in the screen or when the proximity
sensor detects presence.
Additional Condition [No Additional Condition / Do Not Send Unless All
Additional Conditions are 0 / Do Not Send Unless All Additional Conditions are
1 / Do Not Send at Less One of the Additional Conditions is 0 / Do Not Send at
Less One of the Additional Conditions is 1]: condition that must be fulfilled for
sending the welcome object. When selecting any condition, the following
parameter appears:
➢ Number of Condition Objects [1…5]: up to 5 objects can be enabled for
the additional condition.
Welcome Back Object (1-Bit) [disabled/enabled]: checkbox to enable the
sending of a 1-bit value (through “[General] Welcome back”) when the welcome
back function is triggered and the condition (if any) evaluates to true. The desired
value should to be set in Value [Send 0 /
Send 1].
Welcome Back Object (Scene) [disabled/enabled]: checkbox to enable the
sending of a scene run request (through “[General] Scene: send”) when the
welcome back function is triggered and the condition (if any) evaluates to true.
The desired value should to be set in Scene Number [1…64].