User Guide

Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
60
➢ [Changes in 14 Bytes Objects]: when this option is selected, the pop-up will
appear on the screen when a value is received through the objects
“[General][Pop-Up n] Line x”.
Line [1,4] [Fixed Text / Text Received from Object]: sets whether the
corresponding text line will be pre-defined or object-dependent. If “Fixed Text” is
selected, the following parameter will appear
➢ Text: textbox to enter the desired text for the corresponding line.
The 14-byte object “[General][Pop-Up n] Line x” will be shown up to four times per pop-
up, depending on how many text lines have been assigned the option “Text Received from
Object”.
2.1.14.3 WELCOME BACK OBJECT
Z70 v2 can send a specific object to the KNX bus when the user presses a touch button
after a significant amount of time since the last press or presence detection (when the
proximity sensor is enabled). Sending it or not can also depend on an additional,
configurable condition consisting in the evaluation of up to five binary objects.
Any actions that in normal operation may be executed will not be if the welcome back
object is sent to the bus. Thus, if the user presses a button and this causes the welcome
back object to be sent, the normal action of that button will not be triggered.
ETS PARAMETERISATION
After enabling Welcome Back Object from “Advanced” screen (see section 2.1.14), a
new tab will be incorporated into the tree on the left.
Figure 40. Welcome Back Object.