User Guide
Table Of Contents
- Contents
- Document updates
- 1 Introduction
- 2 Configuration
- 2.1 General
- 2.2 Display
- 2.3 Inputs
- 2.4 Thermostat n
- ANNEX I. Video Intercom Operation
- ANNEX II. Internal Call Operation
- ANNEX III. Remote Control via IP
- ANNEX IV. Graphs
- ANNEX V. Differences with Z50 / Z100
- ANNEX VI. Communication Objects
Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
58
2.1.14.2 POP-UPS
This function permits showing the user a pop-up message of up to four lines of text on
the display, each of which can be object-dependant or set in parameters.
It is possible to enable up to 6 pop-ups, each of which can be launched in 3 different ways:
by using a 1-bit object, by using a 1-byte object or by modifying the text of one of the
messages. They can also be launched when activating the different states of the control
of Room State (see section 2.2.2.1.2.6).
The pop-up can be closed pressing the confirmation button inside it or using the 1-bit or
1-byte objects named above.
Figure 37. Pop-up
ETS PARAMETERISATION
After enabling Pop-Ups from “Advanced” screen (see section 2.1.14), a new tab will be
incorporated into the tree on the left.
Figure 38. Pop-ups tab