User Guide
Table Of Contents
- Contents
- Document updates
- 1 Introduction
- 2 Configuration
- 2.1 General
- 2.2 Display
- 2.3 Inputs
- 2.4 Thermostat n
- ANNEX I. Video Intercom Operation
- ANNEX II. Internal Call Operation
- ANNEX III. Remote Control via IP
- ANNEX IV. Graphs
- ANNEX V. Differences with Z50 / Z100
- ANNEX VI. Communication Objects
Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
57
Figure 35. Cleaning Function Message
ETS PARAMETERISATION
After enabling Cleaning Function from “Advanced” screen (see section 2.1.14), a new
tab will be incorporated into the tree on the left.
Figure 36. Cleaning Function.
Time to Exit Cleaning Status [5...15…65535][s] [1…65535][min/h]: timeout to
deactivate the cleaning function after triggered.
Message Notification [Cleaning…]: textbox to enter the desired message.
Notify Expiration [No / Blink Message / Play Sound / Both]: sets whether to
notify the timeout expiration or not. When any of the three later options is
selected, a new parameter shows up:
➢ Length of the Warning [1...
5…65535][s] [1…65535][min/h]: sets the
ahead-time to start the notification prior to the end of the cleaning function.
The “[General] Cleaning Function” one-bit object triggers the cleaning function when it
receives a “1” from the KNX bus.