User Guide
Table Of Contents
- Contents
- Document updates
- 1 Introduction
- 2 Configuration
- 2.1 General
- 2.2 Display
- 2.3 Inputs
- 2.4 Thermostat n
- ANNEX I. Video Intercom Operation
- ANNEX II. Internal Call Operation
- ANNEX III. Remote Control via IP
- ANNEX IV. Graphs
- ANNEX V. Differences with Z50 / Z100
- ANNEX VI. Communication Objects
Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
56
2.1.14 AVANCED
Independent tab for the parameterisation of some advanced functions. These functions
are explained next.
ETS PARAMETERISATION
After enabling the Advanced Configuration from “Configuration” screen (see section
2.1.1), a new tab will be incorporated into the tree on the left.
Figure 34. Advanced Configuration.
Cleaning Function [disabled/enabled]: enables or disables the “Cleaning
Function” tab. See section 2.1.14.1 for details.
Pop-Ups [disabled/enabled]: enables or disables the “Pop-Ups” tab. See section
2.1.14.2 for details.
Welcome Back Object [disabled/enabled]: enables or disables the “Welcome
Back Object” tab. See section 2.1.14.3 for details.
2.1.14.1 CLEANING FUNCTION
This feature is very similar to the touch locking, that is, it locks the touch area, thus
discarding further button touches. The difference is that this function remains active only
during a parameterisable time, and then stops.
This function is intended to let the user clean the touch area with the certainty of not
triggering unwanted actions.
A message is shown during the cleaning state. When the timeout is about to end, making
this message blink or the device beep (or both) is possible too.