User Guide

Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
55
Note: For further information about the configuration and importation of contacts
via web, please refer to the “Webserver Tools” manual (available in the product
section of Z70 v2 in Zennio web portal,
www.zennio.com).
2.1.13.2.1 Contact n
ETS will enable to configure a list of up to 8 contacts for each Z70 v2.
For Z70 v2 to be able to make calls to other screens (Z41 COM or Z70 v2), certain data,
such as the ID and IP address of each contact, will need to be correctly configured.
Otherwise, communication between devices will not take place.
ETS PARAMETERISATION
After enabling Contact n in “Internal Call” subtab, a new tab is created where the name
of the contact that is going to appear in Z70 v2 and the necessary data to be able to
establish communication with other devices is possible to set.
Figure 33. "Contact n" tab
This tab shows the following parameters:
Name [Contact n]: name that will be displayed both in the call log and in the
contact list.
ID [IC_n]: Contact identifier.
IP Address [192.168.1.111]: IP address of the contact.
Important: both the IP address and ID must match the IP Address and My ID set in the
"IP Settings" tab (section 2.1.12) of the device to which the contact refers.