User Guide

Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
52
the KNX object. Choosing the Object Value [1 = Open / 0 = Open] that will
open the door is possible.
Important: For safety reasons, it is recommended not to use this
communication object or to use it under the responsibility of the integrator.
Door n [disabled/enabled]: enables or disables every door, up to 4 for each
outdoor unit.
Note: the door concept in Z70 v2 refers to the switches configured in GetFace IP
in section Hardware → Switches.
➢ Label: name that will appear on the preview, incoming call and ongoing call
panel to identify the door.
➢ HTTP Command Opening [disabled/
enabled]: set whether the HTTP
command is sent when the door is opened.
➢ Automatic Door Opening (DOORMATIC) [
disabled/enabled]: defines
whether each of the doors should open automatically with the set delay. Its
selection will be available whenever the general parameter for automatic
door opening of the outdoor unit is enabled.
For further information about the configuration above parameters of external units
GetFace IP, please refer to the “Z41 COM / Z70 + GetFace IP Configuration Guide” and
the specific documentation of “Zennio GetFace IP” (available at
www.zennio.com).
2.1.13.1.2 General Outdoor Unit
Whenever a call is received from a video intercom whose identification code (ID) does not
match any of the parameterized ones for the rest of the enabled outdoor units (see
outdoor unit ID, section 2.1.13.1.1), the call will be visualized on the generic outdoor unit
panel.
ETS PARAMETERISATION
After enabling Generic Outdoor Unit, in “Video Intercom” (see section 2.1.13.1), a new
tab with the same name is created: