User Guide
Table Of Contents
- Contents
- Document updates
- 1 Introduction
- 2 Configuration
- 2.1 General
- 2.2 Display
- 2.3 Inputs
- 2.4 Thermostat n
- ANNEX I. Video Intercom Operation
- ANNEX II. Internal Call Operation
- ANNEX III. Remote Control via IP
- ANNEX IV. Graphs
- ANNEX V. Differences with Z50 / Z100
- ANNEX VI. Communication Objects
Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
50
2.1.13.1.1 Outdoor Unit n
The video intercom used can be of two types: private or community. The main difference
between them is that community video intercom does not enable the camera image to
be viewed if there is no incoming or ongoing call. In case the unit does not have a camera,
the images will not be viewed in case of any event, no matter what type of video door
phone it is.
Each outdoor unit enables the setting of up to 4 doors, whose opening can be executed
by means of an HTTP command (it is possible to enable secure opening with username
and password) sent to the outdoor unit and/or a communication object sent directly to
the actuator.
It is also possible to enable the sending of a KNX object to the bus each time the door is
opened.
ETS PARAMETERISATION
After enabling any of the outdoor units (see section 2.1.13.1), a new sub-tab "Outdoor
unit n" is displayed with the following parameters:
Figure 30. Outdoor Unit n
Name: text field identifying the parameterised outdoor unit. This name will be
displayed both in the Z70 v2 call log and on the top bar of incoming and ongoing
calls.
Type [Private / Community]: The “Private” type enables access at any time to
the visualization of images from the camera of the outdoor unit.