User Guide
Table Of Contents
- Contents
- Document updates
- 1 Introduction
- 2 Configuration
- 2.1 General
- 2.2 Display
- 2.3 Inputs
- 2.4 Thermostat n
- ANNEX I. Video Intercom Operation
- ANNEX II. Internal Call Operation
- ANNEX III. Remote Control via IP
- ANNEX IV. Graphs
- ANNEX V. Differences with Z50 / Z100
- ANNEX VI. Communication Objects
Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
49
ETS PARAMETERISATION
After enabling Video Intercom in the “VoIP Calls” screen (section 2.1.13), a new tab will
be incorporated into the tree on the left.
Figure 29. Video intercom
“Call Accepted” Label [CALL ACCEPTED]: text to be displayed when the call
is accepted on a synchronised device.
“Call Rejected” Label [CALL REJECTED]: text to be displayed when the call is
rejected on a synchronised device.
Default Ringtone [Ringtone 1 / … / Ringtone 7]: melody played by Z70 v2 when
receiving a call from an video intercom. The tone can be changed from the
configuration page (see section 2.2.1.2.3) or through the "[VoIP] Video
Intercom Ringtone" object.
Numer of Tones [0…3…10]: set how many times will sound the ringtone.
Play Ringtone Object Value [1 = Play Ringtone / 0 = Play Ringtone]: define the
polarity of “[VoIP] Play Video Intercom Ringtone” object.
Generic Outdoor Unit [disabled/enabled]: checkbox that enables a new tab with
the same name in the left menu where the generic outdoor unit is configured
(see section 2.1.13.1.2).
Outdoor Unit n [disabled/enabled]: checkbox that enables a new tab with the
same name in the left menu where each video intercom is configured (see
section 2.1.13.1.1).