User Guide

Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
47
Internal Calls [disabled/enabled]: enables or disables “Internal Call” tab for the
configuration of internal calls to other devices (Z41 COM or Z70 v2). See section
2.1.13.2 for more details.
If any of the above parameters are enabled, the following will appear:
Default Ring Volume (after Programming) [No sound / 1 / 2 / 3 / 4 / 5]: define
the VoIP calls volume after Programming.
Synchronize with other Devices in the Same Network [disabled/enabled]:
enables the device to share the call status and history with all other units
connected to the same network that have this functionality enabled. Then the
following parameter will also appear:
➢ Synchronization Password: field that must match in all the devices to
synchronise.
Note: Synchronisation with other devices is only available for Z70 v2. If there is a
Z41 COM in a system, synchronisation will not be performed.
In addition, when the parameters Video Intercom and/or Internal Calls are enabled, the
following objects will appear:
“[VoIP] “Do Not Disturb” Mode”: 1-bit object that enables and disables the do
not disturb mode of the Z70 v2 VoIP functionality. While this mode is active, Z70
v2 will not receive any incoming calls, but the calls will be recorded in the log.
“[VoIP] Video Intercom Ringtone” or “[VoIP] Internal Call Ringtone”: 1-byte
object to change the video intercom or internal call ringtone.
“[VoIP] Ringtone Volume”: object to change the volume of the incomming calls
ringtone.
“[VoIP] Active Call”: this object is sent to the bus (with value ‘1’) when a call
starts and (with value ‘0’) ends, indicating whether the call is active or not. The
purpose of this object is, for example, to be able to mute a stereo during a call
and have the sound resumed at the end of the call.
“[VoIP] Play Video Intercom Ringtone”: 1-bit object that plays the video
intercom ringtone once.