User Guide
Table Of Contents
- Contents
- Document updates
- 1 Introduction
- 2 Configuration
- 2.1 General
- 2.2 Display
- 2.3 Inputs
- 2.4 Thermostat n
- ANNEX I. Video Intercom Operation
- ANNEX II. Internal Call Operation
- ANNEX III. Remote Control via IP
- ANNEX IV. Graphs
- ANNEX V. Differences with Z50 / Z100
- ANNEX VI. Communication Objects
Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
46
2.1.13 VOIP CALLS (LICENSE REQUIRED)
Note: VoIP calls functionality requires a license installation. If not, even being possible to
configure it from ETS, its use will not be accessible
Z70 v2 is capable of receiving, over its Ethernet connection, voice and video calls from:
A Zennio indoor unit: Z41 COM or Z70 v2. These calls are referred in this
document as internal calls.
A Zennio outdoor unit: GetFace IP. These calls are referred in this document
as video intercom calls.
The same GetFace IP outdoor unit can call more than one Z70 v2 at the same
time. For that purpose, the different Z70 v2 must be synchronized and connected
to the same network. The synchronization will allow actions performed on one of
the screens to be notified to the others.
ETS PARAMETERISATION
Figure 28. VoIP Calls
My ID [MY_ID]: identification code of the Z70 v2 required to communicate with
other devices.
Note: the characters included in this field must comply RFC 2396 standard.
Video Intercom [disabled/enabled]: enables or disables “Video Intercom” tab for
the configuration of external video intercom (GetFace IP). See section 2.1.13.1
for more details.