User Guide
Table Of Contents
- Contents
- Document updates
- 1 Introduction
- 2 Configuration
- 2.1 General
- 2.2 Display
- 2.3 Inputs
- 2.4 Thermostat n
- ANNEX I. Video Intercom Operation
- ANNEX II. Internal Call Operation
- ANNEX III. Remote Control via IP
- ANNEX IV. Graphs
- ANNEX V. Differences with Z50 / Z100
- ANNEX VI. Communication Objects
Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
45
• IP Address [192.168.1.100].
• Subnet Mask [255.255.255.255.0].
• Specify Gateway [
Disabled/Enabled]: Enabling this allows you to enter a
gateway [
192.168.1.1]. This only needs to be enabled if the Z70 v2 is on
a different network to the other units it is communicating with.
Note: If VoIP functionality is enabled, 2 scenarios are possible:
➢ Same network: The IP assignment can only be static, and the IP will be the
same for both the device (the one used for Webserver, remote functionality,
or setting the time via NTP), and the VoIP functionality.
➢ Different network: The IP assignment for the display can be either DHCP
or static:
• DHCP: In this case the IP of the display will be assigned via the DCHP
protocol, while the IP for the VoIP functionality will be defined by the user
statically.
• Static: Both the IP assignment for the display and for the VoIP functionality
will be statically assigned (although they will be different), with the user
defining all the parameters.
Figure 27. IP Configuration with VoIP enabled on different network