User Guide
Table Of Contents
- Contents
- Document updates
- 1 Introduction
- 2 Configuration
- 2.1 General
- 2.2 Display
- 2.3 Inputs
- 2.4 Thermostat n
- ANNEX I. Video Intercom Operation
- ANNEX II. Internal Call Operation
- ANNEX III. Remote Control via IP
- ANNEX IV. Graphs
- ANNEX V. Differences with Z50 / Z100
- ANNEX VI. Communication Objects
Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
44
be indicated to access Webserver Tools, on the outdoor unit (GetFace IP)
or on a contact of another display to make an internal call.
Note: it is recommended to set this IP address out of the range of
addresses assigned by the home router to prevent possible conflicts with
the IP address visible to the internet.
➢ Subnet Mask [
255.255.255.0]: must match the mask of the network to
which Z70 v2.
➢ Specify Gateway [disabled/enabled]: when enabled permits introduce a
gateway [
192.168.1.1].
➢ Primary DNS [
8.8.8.8]: Maintains the authoritative information of a domain
name, obtained from its own configuration.
➢ Secondary DNS [
8.8.4.4]: copies its configuration from the primary
Figure 26. IP Configuration with VoIP enabled on same network
VoIP [disabled/enabled]: If enabled, allows communication with external
(GetFace IP) or internal (Z41 COM or other Z70 v2) units.
➢ Different network [
disabled/enabled]: Allows to select whether the network
for the VoIP functionality is on a different network than the device. When
enabled, the following parameters are displayed: