User Guide

Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
35
Figure 19. Touch Locking.
1-Bit Object [enabled]: enables the 1-bit object “[General] Touch Locking” to
trigger the touch lock.
➢ Value [
0 = Unlock, 1 = Lock / 0 = Lock, 1 = Unlock]: parameter to select
which value should trigger which action when received through the indicated
object.
Scene Object [disabled/enabled]: enables the touch locking and unlocking when
receiving the configured scene value through the object (“[General] Scene:
receive”).
➢ Lock: Scene Number (0 = Disabled) [0/1…64]: scene number that locks
the touch.
➢ Unlock: Scene Number (0 = Disabled) [0/
1…64]: scene number that
unlocks the touch.
Message Notification [Touch Locked]: textbox to enter the desired message.
2.1.10 SOUNDS
Z70 v2 emits 3 types of sounds, depending on the action performed:
Press Confirmation: short beep indicating that the user has pressed a button.
This only applies to step controls, i.e., controls that go through a certain range
of values and that do not send a value after every touch, and to page accesses.
Sending Confirmation: a slightly longer and sharper beep than the previous
one. It indicates the sending of an object to the bus as a result of a press.