User Guide
Table Of Contents
- Contents
- Document updates
- 1 Introduction
- 2 Configuration
- 2.1 General
- 2.2 Display
- 2.3 Inputs
- 2.4 Thermostat n
- ANNEX I. Video Intercom Operation
- ANNEX II. Internal Call Operation
- ANNEX III. Remote Control via IP
- ANNEX IV. Graphs
- ANNEX V. Differences with Z50 / Z100
- ANNEX VI. Communication Objects
Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
34
Note: To ensure correct measurement of the temperature probe, when the temperature
probe is enabled, the display will be permanently switched on.
2.1.8 AMBIENT LUMINOSITY SENSOR
Z70 v2 includes a sensor to measure the ambient luminosity level, so that the brightness
of the display can be adjusted according to the current luminosity of the room.
Please refer to the specific manual “Luminosity and Proximity Sensor” (available in the
Z70 v2 product section at the Zennio homepage,
www.zennio.com) for detailed
information about the functionality and the configuration of the related parameters.
2.1.9 TOUCH LOCKING
The touch panel of Z70 v2 can be optionally locked and unlocked anytime by writing a
configurable one-bit value to a specific object provided for this purpose. It can also be
done through scene values.
While locked an informative message will be shown. In addition, any user presses on the
screen will be ignored: no action associated with controls will be carried out.
Figure 18. Touch Locked Message.
ETS PARAMETERISATION
After enabling Touch Locking from “Configuration” screen (see section 2.1.1 a new tab
will be incorporated into the tree on the left.