User Guide
Table Of Contents
- Contents
- Document updates
- 1 Introduction
- 2 Configuration
- 2.1 General
- 2.2 Display
- 2.3 Inputs
- 2.4 Thermostat n
- ANNEX I. Video Intercom Operation
- ANNEX II. Internal Call Operation
- ANNEX III. Remote Control via IP
- ANNEX IV. Graphs
- ANNEX V. Differences with Z50 / Z100
- ANNEX VI. Communication Objects
Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
33
ETS PARAMETERISATION
After enabling Screensaver from “Configuration” screen (see section 2.1.1), a new tab
will be incorporated into the tree on the left.
Figure 17. Screensaver Tab
Image [disabled]: parameter to show an image in the screensaver. For this
functionality to be available, the Enable Web Configuration parameter must be
active (see section 2.1.1).
Time/Date [disabled/enabled]: when this parameter is enabled, the current date
and time is displayed centered on the screensaver.
External Temperature [disabled/enabled]: when this parameter is enabled, the
external temperature received by the “[General] External Temperature” object
is displayed centered on the screensaver.
Background Color [#000000]: color set for the background when there is no
image in the screensaver.
Text Color [#FFFFFF]: screensaver font color.
2.1.7 INTERNAL TEMPERATURE SENSOR
Z70 v2 is equipped with an internal temperature sensor for monitoring the ambient
temperature of the room, so that the device can report it to the KNX bus and trigger several
actions when the temperature reaches certain values.
Please refer to the specific documentation of the “Temperature Probe” available at the
Zennio homepage,
www.zennio.com, for detailed information about the functionality and
the configuration of the related parameters.