User Guide
Table Of Contents
- Contents
- Document updates
- 1 Introduction
- 2 Configuration
- 2.1 General
- 2.2 Display
- 2.3 Inputs
- 2.4 Thermostat n
- ANNEX I. Video Intercom Operation
- ANNEX II. Internal Call Operation
- ANNEX III. Remote Control via IP
- ANNEX IV. Graphs
- ANNEX V. Differences with Z50 / Z100
- ANNEX VI. Communication Objects
Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
32
Figure 16. Screensaver
There will also be an option to show an image on the screensaver. This image will be
loaded from the webserver.
Note: Please refer to the user manual “Webserver Tools” (available in the Z70 v2 product
section at the Zennio homepage, www.zennio.com) for detailed information about its
functionality and the configuration.
The screensaver disappears when activity is triggered (either by a pulsation, proximity
detection or any other event that triggers activity).
Notes:
If a Pop-Up is being displayed (see section 2.1.14.2), screensaver will not
become active.
If a pop-up is activated when the screensaver is active (see touch locking 2.1.9,
cleaning function 2.1.14.1 or Pop-Ups 2.1.14.2) this pop-up will become show
up over screensaver.