User Guide
Table Of Contents
- Contents
- Document updates
- 1 Introduction
- 2 Configuration
- 2.1 General
- 2.2 Display
- 2.3 Inputs
- 2.4 Thermostat n
- ANNEX I. Video Intercom Operation
- ANNEX II. Internal Call Operation
- ANNEX III. Remote Control via IP
- ANNEX IV. Graphs
- ANNEX V. Differences with Z50 / Z100
- ANNEX VI. Communication Objects
Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
25
changing the scale of the temperatures. By receiving one ‘0’ through this object,
the scale will switch to Celsius, while after receiving one ‘1’ it will switch to
Fahrenheit.
The selected scale applies to any temperatures shown on the screen and takes
precedence over the scale corresponding to the locale.
2.1.3 BACKLIGHT
Z70 v2 enables managing the brightness of the display according to two operating
modes: normal mode and night mode.
Note: Contrast is not a configurable feature in the device.
Please refer to the specific manual “Brightness” (available in the Z70 v2 product section
at the Zennio website,
www.zennio.com) for detailed information about the functionality
and the configuration of the related parameters.
2.1.4 SECURITY
Any box or page will be given the possibility of restricted access by password. Up to
two security levels can be configured, with the level 2 access password taking priority
over the level 1 password, so that any controls page or box can be protected by one or
the other, or by none at all.
Buttons that lead to a protected page or box will show a little lock icon overlaid on their
lower right corner.
Figure 10 shows the “enter password” dialog shown to the user when trying to access a
protected page.