User Guide

Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
17
Show Time [disabled/enabled]: permits setting whether the current time is
displayed in the upper-left corner of any page or not.
Important: the time will not be displayed on the top bar until both a time and a
valid date have been set.
Show Temperature [No / Internal Temperature Probe/ External Value]: sets
whether the current temperature should show or not in the upper right corner
of every page. If “External Value” is chosen, an object named “[General]
External Temperature” will be enabled, so that it can be grouped with any
other object that sends temperature values.
Enables to choose whether the source of the current temperature measurement
will be an "External value" or the value provided by the "Internal temperature
probe".
Synchronize Clock Master via NTP [disabled/enabled]: if enabled, the device
will update the date and time obtained from the NTP server according to the
configured time zone. In addition, the following parameters will be displayed:
➢ Time Zone: drop-down list to select a time zone from the UTC
(Coordinated Universal Time) time standard.
• Daylight Saving Time (DST) [
disabled] / [disabled/enabled]: enables or
disables the automatic time change during the summer season. It will
only be available in the time zones that have summer time changeover.
➢ Domain of NTP Server [
0.pool.ntp.org]: NTP server used for internal clock
synchronisation.
➢ Date and Time Periodical Sending [0 …
10 … 65535] [x 1min]: time
period after which the date and time objects (“[General] Date” and
“[General] Time of Day”) will be sent to the bus.
If the parameter Synchronize Clock Master via NTP is disabled, the following
parameter is displayed:
➢ Date and Time Update Request Delay [
disabled/enabled]: allows
selecting a delay [1…65535] [s/min/h] for the date and time request to the